耐普UPS蓄電池安裝前注意事項：

1、檢查NPP電池無異常，將其安裝在指定地點（如電池房）。

2、避免耐普電池安裝在靠近熱源（如變壓器）的地方。

3、如將電池安放在電池房，應盡可能將其放在電池房最低處。

4、因為耐普蓄電池貯存時可能產生易燃氣體，安裝時應避免靠近產生火花的裝置(如保險絲)。

5、連接前，擦亮電池端子，使其呈現金屬光澤。

6、小心導電材料短接電池正負端子。

7、多個耐普電池一起使用時，首先保證電池間連接正確，再將電池與電源設備或負載連接。在這種情況下，電池正極與電源設備或負載的正負極連接，負極與負極連接。如果電池與電源設備連接不正確，電源設備會被損壞，一定要注意不要連接錯誤，切記正負極連接正確。

8、接線時注意要連接牢固，每個連接螺母與螺栓一定要扭緊，但不可用力過大，以免損傷端子。

1. Check that NPP battery is normal and install it in the designated place (such as battery room).

2. Avoid installing the battery near a heat source (such as a transformer).

3. If the battery is placed in the battery room, it should be placed in the lowest place of the battery room as far as possible.

4, because the storage battery can produce flammable gas, installation should avoid close to the spark device (such as fuse).

5. Before connection, polish the battery terminal to give it a metallic luster.

6. Be careful to connect the positive and negative terminals with conductive materials.

7. When multiple napp batteries are used together, first ensure the correct connection between the batteries, and then connect the batteries to the power supply device or load.In this case, the positive pole of the battery is connected to the positive and negative pole of the power supply device or load, and the negative pole is connected to the negative pole.If the battery is not properly connected to the power supply device, the power supply device will be damaged. Be careful not to make the wrong connection.

8, pay attention to the connection when wiring, each connection nut and bolt must be tightened, but not too strong, so as to avoid damage to the terminal.